Welcome! Log In Create A New Profile

Advanced

Wet Compass SIOC Code question

Posted by Reensel 
Wet Compass SIOC Code question
September 17, 2018 12:01PM
Hi all.

I have a question regarding my SIOC Code.

First - this Code works - so far so good BUT if I change the Location (or Airport) in P3D the USB Stepper Card doesnt recognize it and I have to Reload / calibrate the Compass again and then it works. Is there any other opportunity to have that under control?

Here is my Code:

VAR 0001, NAME 0USB_STEPPER, LINK USB_STEPPER, DEVICE 10, OUTPUT 3, POSL 6, POSC 0, POSR 5, TYPE H // #SC#WETCompass_USB_Steppe# WETCOMPASS

VAR 0002 LINK FSUIPC_IN OFFSET $02CC LENGTH 8 NUMBERS 1 // FSIMULATOR COMPASS

{

L0 = V0002 * 10

V0001 = L0 // SEND DEGREES TO STEPPER MOTOR

}
Sorry, only registered users may post in this forum.

Click here to login