Engineering and Manufacturing, Under One Roof
Electronics, mechanics and software developed and built in-house in our facilities since 2003. From a single custom panel to a complete simulator platform designed around your requirements.
We do not integrate parts. We make them.
Every mechanism, panel and circuit board in our simulators is designed and manufactured by our own team. That means full control over quality, spare parts availability for the entire product life, and the freedom to adapt any component to your project.
When you need something that does not exist in any catalogue, this is where it gets built.
Electronics, software and motion — all in-house
Electronics manufacturing
Our own SMT pick & place line assembles the boards that drive every module.
Testing & quality
Every board is individually tested on the bench before it reaches a cockpit.
SIOC — our own software
The control software behind our hardware for two decades, developed and maintained by us.
Motion platforms
Six-axis motion testing for full-motion simulator development.
From bare components to finished flight deck
A320 thrust quadrant
Board assembly
Component preparation
Backlit engraving
Control Loading System
From your idea to a buildable design
Custom projects start on the drawing board. This enclosure concept was developed for a customer around their space, budget and training requirements — before a single part was cut.
Custom breaker panel, built to specification
And this is how ideas end up: real hardware, engraved, backlit and wired, manufactured as a one-off for a specific customer installation.
The same modules, available off the shelf
Every custom project is backed by our catalogue of professional cockpit modules.
Pedestals
Complete A320 and 737 pedestal modules.
Overhead panels
Fully functional backlit overhead units.
Instrument panels
MIP units ready to integrate with your setup.
Computer racks
Pre-configured and tested simulation computers.
Four steps from idea to installation
1. Consultation
Tell us your requirements: space, aircraft type, training goals and budget.
2. Design
Our engineering team develops the concept, drawings and specification.
3. Manufacture
Mechanics, electronics and software built and tested in our facilities.
4. Delivery
Installation, commissioning and lifetime technical support.
Have a project in mind?
Describe what you need and our engineering team will study its viability and prepare a proposal — from a single panel to a complete platform.
Contact our team